- 25 -
5.1
Changing the battery adapter
In order to mount another battery adapter, proceed as follows:
The charging station must be switched off and the power supply must be disconnected
prior to changing the adapter. Then, the adapter which needs to be changed must be loo
-
sened, so that the circuit board of the charger is accessible.
There are 4 different designs / basic forms of battery adapters. After loosening the moun
-
tings, all 4 designs are removed in the same manner. To do this, lift the adapter up slightly
and pull it out to the top.
WARNING
Only authorized specialists are permitted to change the battery adapter. For
the exchange is no electrical qualified personnel required.
DANGER
Risk of injury from sharp edges
Sharp edges on the cutouts of the battery adapter can cause injuries.
•
Watch out for sharp edges.
•
If necessary, wear gloves to avoid cuts.
Design 1
Rotate the two flathead screws approx. half a turn.
loosen (CCW)
mount (CW)
Summary of Contents for HST-MV3-02
Page 31: ...Notes ...
