HRT Mini-Cat UV-1, Manual

Page: 6 / 16

Miniature VGA over CAT5 Extension System
4
1.4 Features
•
Eliminates the need for bulky, expensive and hard to build
multi-coaxial cables for High-Resolution A/V extension
•
Amplifies the signal for clean and crisp transmission
•
Differential signaling eliminates ground loops and noise
•
Handles resolutions up to 1600x1200 at any refresh rate
•
Rugged, Reliable, Compact size
•
Only one end requires power in most applications. Power
supply can be connected at the sending or the receiving end,
whichever convenient.
•
Drive standard CAT5 cables to 500 feet for (VGA and
Component video versions) or to 1200 feet for (Composite
Video and Stereo Audio version)
2. Installation
1. Connect the VGA in (HD-15) connector of the UV1-Sender to the
computer's video port using the supplied cable (see figure 2.1).
2. Connect the supplied power adapter to the power input connector
on either of the units. Note that only one power adapter is used to
power both the sender and receiver. It can be plugged into either of
them. Please be sure to insert the power connector fully. You may
need to push down on the connector as shown below. Check the red
light next to the RJ45 connector to verify unit’s power.
VGA
CAT-5
Remote Monitor
Figure 2.1
VGA
Sender
Receiver
Figure 2.2