Solid Brace System for Oversized Isolation Bases (Accessory) –
The
MXR Audio
stand can also be set up to accommodate a larger isolation base at the top of the
frame. This is often done for large turntable systems but the brace system can be
used to support and large audio component. The billet machined brace system is
installed directly onto the existing MXR brackets. With the HRS logo in proper
orientation carefully lower the brace system on top of the brackets. The bearing
tape in the machined pockets of the solid brace system will come in contact with
the top of the bracket. There is a precise fit of the width of the brace system to the
frame. Be very careful not to scratch the frame during installation of the solid
brace system. If necessary loosen the top brace that connects the panels in the
MXR frame prior to installation of the solid brace inserts and re tighten after
assembly. Once the solid brace inserts are in place you can load the oversized
isolation base into the top channels of the solid brace system.
