−
22
−
(3) 供料指的位置调整
1) 用六角扳手 (M4 用 ) 拧松供料指安装螺丝
1
。(
A
方向 )
2) 把供料指
2
对准传送器的操作孔的中心。
3) 用六角扳手拧紧供料指的安装螺丝
1
。(
B
方向 )
( 注意 ) 拧紧螺丝后，请再次确认供料指的位置。
(3) Adjusting the position of the feed finger
1) Loosen feed finger mounting screw
1
using a hexagonal wrench key (for M4). (direction
A
).
2) Adjust feed finger
2
to the center of the pilot hole of the carrier.
3) Tighten feed finger mounting screw
1
with a hexagonal wrench key (direction
B
).
(Caution) After tightening the screw, check again the position of the feed finger.
(4) Adjusting the mounting position of the scrap guard
1) Loosen scrap guard mounting screw
3
using a hexagonal wrench key. (for M4) (direction
A
).
2) Adjust the height so that scrap guard
5
does not come in contact with carrier
4
coming out from the cut-off
punch.
Adjust the longitudinal position so that crimper
6
does not come in contact with scrap guard
5
.
3) Tighten scrap guard mounting screw
3
with a hexagonal wrench key (direction
B
).
(4) 废屑防护器安装位置的调整
1) 用六角扳手 (M4 用 ) 拧松废屑防护器安装螺丝
3
。(
A
方向 )
2) 调整高度，不让从切断钳出来的传送器
4
与废屑防护器
5
相碰。
然后，调整前后位置，不让夹杆
6
碰到废屑防护器
5
。
3) 用六角扳手拧紧废屑防护器安装螺丝
3
。(
B
方向 )
Summary of Contents for AP105
Page 42: ... 29 MEMO ...
