3)
LAN Setup
— Please follow the steps below to setup your UBlocker using an
Ethernet cable to connect directly to your router (LAN version). You may skip this
section (3) if you wish to setup your UBlocker to connect via WIFI only (see step 4
below).
Connect Ethernet cable (included) from your existing router to the Ethernet port on
the UBlocker, as shown below:
4) WIFI setup
— Optionally, you can connect your UBlocker WL via WIFI by skipping
step 1a) above, and following these steps to connect it via WIFI.
Preparation:
In order to setup your UBlocker via WIFI, you need a WIFI-enabled
device e.g. smartphone, tablet or labtop. This is a one-time setup!
4a) Next, using your WIFI-enabled device, go to Settings > WIFI
Wait until you see a device called UBlocker under “Choose a network” appear in the list
of available networks. Select “UBlocker” from the list, and type password:
ultimateblocker
when prompted.
Once you see the UBlocker shown as connected, the close Settings > Wifi. (Note: It
may say “No Internet” … this is okay!).
4b) Next, open a browser (e.g. safari, chrome, firefox, IE) on your WIFI-enabled device
and type: http://192.168.2.1 in the address bar and press enter. You should see this:
Type your WIFI router’s SSID and Password of your wifi router and press “Update
Wi-Fi” button.
