calls.
2. When you receive an incoming call, simply please press “*0” button on the handset (connected on the same
phone line in series or parallel). The blocker’s LCD screen would display “DONE”, it means this number has been
stored in the black list. Calls from numbers in the Black List are blocked automatically (disconnected) if numbers
call again in the future.
14)
Block Calls with NO Caller ID (e.g. Unknown, 000-000-0000, Out of Area)
While on standby mode, press and hold the
〖
BLACK LIST
〗
button for 3 seconds, the LCD screen would display: Date
Time, then press the
〖
DOWN
〗
button 2 times to show ‘Block No Cid’., then press
〖
ACCEPT
〗
button. The LCD
screen should show “ON” or “OFF”. Use the
〖
DOWN
〗
button to change, as desired.
15)
Turning ON/OFF the Voice Recording Feature
While on standby mode, press the
〖
VOICE
〗
button to switch the VOICE recording to A (English), B (Spanish), C
(German), or OFF (default). When the VOICE feature is on A, B or C, all incoming calls that are not White List will
be hear this recording. The recording will play 3 times, and then disconnect the call. Your phone will only ring
for numbers in the White List – Welcome to total privacy!
You can also modify this setting via the programming menu.
16)
Blocking Area Codes
You can block up to 20 area codes (or prefixes up to 10 digits long) you wish to block. To add area codes, follow
the steps: Press and hold the
〖
UP/SET
〗
button (left side) for 3 seconds then press
〖
DOWN
〗
button once to find
‘Block Set’. Then press
〖
ACCEPT
〗
button accept, then it shows CO1---------- , then press
〖
DOWN
〗
button to set
the first area digit (choice 0-9 by pressing down button) once confirm then pressing the
〖
ACCEPT
〗
button , then
set the second digit ... etc. When done press the
〖
ACCEPT
〗
button once again. Repeat these steps to program
area code C02 - C20). Note: Some carriers in the US are still sending the 1+area code. So, you may need to block
1XXX instead of just the area code XXX.
17)
Parallel Telephone Pick up the Handset to Make a Call
When the parallel telephone picking up the handset, the blocker’s LCD screen display “-” and flashing and begin
time accounting; The blocker’s LCD screen display the dialing number; After hanging up the phone, the blocker
would store the dialed number and call duration to outgoing call numbers.
18)
Turning the Ringer ON/OFF (default = ON)
You can turn the ringer ON/OFF on your call blocker via the programming menu. When in standby mode, please
press and hold the left side of the
〖
UP/SET
〗
button for 3 seconds, the LCD screen should display: Date Set, then
press the
〖
DOWN
〗
button once to display: rING sET, press the
〖
ACCEPT
〗
button, the LCD should display “ON”.
Press the
〖
DOWN
〗
button once to change to “OFF”, then press the
〖
ACCEPT
〗
button.
19)
Factory Reset
To reset your call blocker (erase all settings as ‘factory reset’), lift off the handset of the phone connected on the
phone port of the blocker and press *#018# -- The display should display “erased”.
For additional information or support on the
, please contact
