HPRT TP809, Programming Manual

Page: 8 / 62

TP809 Programming Manual
2
Print downloaded bit image
[Format] ASCII GS / m
Hex 1D 2F m
Decimal 29 47 m
[Range] 0 ≤ m ≤ 3, 48 ≤ m ≤ 51
[Description] Prints downloaded bit image defined by GS
∗
and using the mode specified by m.
m Mode Vertical direction Horizontal direction
0, 48 Normal
203dpi 203dpi
1, 49 Double - width
203dpi 101dpi
2, 50 Double - height
101dpi 203dpi
3, 51i Quadruple
101dpi 101dpi
Set graphics data
[Format] ASCII GS 8 L p1 p2 p3 p4 m fn [parameters]
Hex 1D 38 4C p1 p2 p3 p4 m fn [parameters]
Decimal 29 56 76 p1 p2 p3 p4 m fn [parameters]
• In the description below, only GS (L is used for explanation).
• Note that GS (L and GS 8 L have the same function).
• If the [parameters] in the Format column in the table below exceed 65533 bytes, use GS
8 L.
• The only differences between GS (L and GS 8 L are as listed below. The format for GS 8 L
is not provided in the following descriptions; however, [Range], [Default], [Description],
and [Notes] for parameters other than those listed in the table below are the same as for
GS ( L. <Parameters specifying the number of parameters after pH or p4>
Command Parameters Structure Maximum value
GS ( L pL, pH 2 bytes 65,535
GS 8 L p1, p2, p3, p4 4 bytes 4,294,967,295
• Processes graphics data.
• pL, pH specify (pL + pH × 256) as the number of bytes after pH (m, fn, and
[parameters]).
• fn specifies the function.
• [parameters] specify the process of each function.