4.
Click
Add
. A wizard prompts the necessary steps to add a new source appliance to the list. Provide
the serial number of the appliance and specify initial access permissions for all libraries and all shares
on that appliance.
5.
Once the appliance is added to the list of Source Appliances, permissions can be configured for it.
Table 16: Source Appliances parameters
Serial Number
The serial number for the required Service Set. This information can be found
on the top-level
StoreOnce
page.
Select the appropriate Service Set.
Appliance Name
The name of the appliance for which you have specified the serial number and
cannot be altered.
Appliance Status
The status of the appliance for which you have specified the serial number
and cannot be altered.
Appliance Address
The address of the appliance for which you have specified the serial number
and cannot be altered.
Configured Mappings
Indicates whether any mappings have been configured on the source
appliance. This is important because any mappings that already exist will be
retained regardless of any access permissions you subsequently set up for
libraries and shares on that appliance.
To configure permissions (administrators only)
• Select the source appliance in the list. There are two tabs; one for
Libraries
, and one for
Shares
.
• Click
Edit
. Check the Access box for those shares and libraries to which access will be granted. These
are the shares and libraries that will be displayed when the mapping configuration step is run in the
Replication wizard. It will not be possible to create a new share or library from the wizard.
• Click
Update
to apply the permissions.
Local Settings (Replication) tab
This tab contains three additional tabs that show the settings for the local StoreOnce System:
•
on page 60
•
on page 62
•
on page 62
General Settings tab
Users with an administrator login may edit and maintain these settings. Other users may only view them.
60
Local Settings (Replication) tab