IMPORTANT:
The left and right sides of the chassis are oriented 180° from each other.
Components that are installed on one side of the chassis must be turned 180° when they are
installed on the opposite side.
2.
on page 28).
3.
on page 28).
4.
Place the server on a flat, level work surface.
5.
on page 29).
6.
Open the front bracket (
on page 29).
7.
Remove the air baffle (
on page 30).
8.
Remove the processor-heatsink module:
a.
Allow the heatsink to cool.
b.
Loosen the heatsink nuts in the order specified by the label on the heatsink (4 - 3 - 2 - 1).
c.
Lift the processor-heatsink module, away from the system board.
d.
Turn the module over and place it on a work surface with the processor facing up.
e.
Install the dust cover.
9.
Release the thermal grease tension between the processor and heatsink:
a.
Locate the tension release slot between the frame and heatsink.
The slot is across from the Pin 1 indicator, near the corner.
b.
Insert a 1/4" flathead screwdriver into the slot.
Be sure that the screwdriver is between the frame and the heatsink.
c.
Gently rotate the screwdriver to release the tension of the thermal grease.
Removal and replacement procedures
41
Summary of Contents for ProLiant XL230k Gen10
