Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
on page 27.
2.
Disconnect all peripheral cables from the server.
3. Remove the server from the chassis
on page 27.
5. Remove the secondary riser cage
on page 30.
6. Remove the primary riser cage
on page 32.
7.
If installed,
remove the expansion board from the riser board
8.
If present,
disconnect the storage controller backup power cable from the riser board
9.
Remove the primary riser board.
To replace the component, reverse the removal procedure.
Removing and replacing the secondary riser board
CAUTION:
Before replacing a DIMM, expansion board, or other similar PCA components due to a
perceived hardware error, make sure first that the component is firmly seated in the slot. Do not
bend or flex circuit boards when reseating components.
Prerequisites
Before you perform this procedure, make sure that you have a T-10 and T-15 Torx screwdrivers available.
Procedure
1.
2.
Disconnect all peripheral cables from the server.
Removal and replacement procedures
51
Summary of Contents for ProLiant DX190r Gen10
Page 21: ...Customer self repair 21...
Page 22: ...22 Customer self repair...
Page 23: ...Customer self repair 23...
