4.
Remove the side bracket.
Remove the primary riser cage
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
either riser blank or the riser cage is installed.
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
on page 27.
2.
Disconnect all peripheral cables from the server.
3. Remove the server from the chassis
on page 27.
32
Removal and replacement procedures
Summary of Contents for ProLiant DX190r Gen10
Page 21: ...Customer self repair 21...
Page 22: ...22 Customer self repair...
Page 23: ...Customer self repair 23...
