Procedure
on page 19.
2.
Disconnect all peripheral cables from the server.
3. Remove the server from the chassis
on page 19.
4.
If a secondary riser cage is installed,
.
5.
Do one of the following:
•
Remove the secondary riser blank
•
Remove the secondary riser cage
on page 27.
6.
Remove the primary riser blank.
Install the primary riser blank
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1.
Install the primary riser blank.
Operations
31
