HPE ProLiant DL580 Gen10, User Manual

Page: 80 / 158

CAUTION:
To avoid damaging the connectors, always install the air baffle into the server before installing the
riser cages.
19. Install a primary PCIe riser cage with a 4-port NVMe riser card installed ( Installing the primary PCIe
riser cage on page 38).
20. Install the butterfly PCIe riser cage ( Installing a butterfly PCIe riser cage on page 80).
21. Install the access panel ( Installing the access panel on page 37).
22. Install the server into the rack ( Installing the server into the rack on page 53).
23. Connect each power cord to the server.
24. Connect each power cord to the power source.
25. Power up the server on page 32.
Installing a butterfly PCIe riser cage
CAUTION:
To prevent damage to the server or expansion boards, power down the server and remove all AC power
cords before removing or installing the PCI riser cage.
Prerequisites
Before installing this option, be sure that you have the following:
• The components included with the hardware option kit
• A T-10 Torx screwdriver might be needed to unlock the access panel.
Procedure
1. Power down the server on page 32.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack ( Extending the server from the rack on page 32).
• Remove the server from the rack ( Removing the server from the rack on page 33).
4. Remove the access panel ( Removing the access panel on page 36).
80 Installing a butterfly PCIe riser cage