HPE ProLiant DL20, Maintenance And Service Manual

Page: 58 / 109

To replace the component, reverse the removal procedure.
Replacing the two-slot PCIe riser board
About this task
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
To prevent damage to electrical components, take the appropriate anti-static precautions before
beginning any installation, removal, or replacement procedure. Improper grounding can cause
electrostatic discharge.
Procedure
1. If installed, remove the security bezel .
2. Power down the server .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
• Extend the server from the rack
• Remove the server from the rack
5. Remove the access panel .
6. Disconnect any internal cables that are connected to the expansion board.
7. Remove the PCI riser cage.
58 Replacing the two-slot PCIe riser board