HPE ProLiant DL180, User Manual

Page: 119 / 172

• Extend the server from the rack.
• Remove the server from the rack.
6. Place the server on a flat, level work surface.
7. Remove the access panel .
8. Remove any components or cables that may prevent access to the TPM connector.
9. Proceed to Installing the TPM board and cover on page 119.
Installing the TPM board and cover
Procedure
1. Observe the following alerts:
CAUTION: If the TPM is removed from the original server and powered up on a different server,
data stored in the TPM including keys will be erased.
CAUTION: The TPM is keyed to install only in the orientation shown. Any attempt to install the
TPM in a different orientation might result in damage to the TPM or system board.
2. Align the TPM board with the key on the connector, and then install the TPM board. To seat the board,
press the TPM board firmly into the connector. To locate the TPM connector on the system board, see
the server label on the access panel.
3. Install the TPM cover:
a. Line up the tabs on the cover with the openings on either side of the TPM connector.
b. To snap the cover into place, firmly press straight down on the middle of the cover.
Hardware options installation 119