HPE LSQM2MPUD0, Manual

Page: 1 / 4

Manual version: 6PW108-20180130 BOM: 3123A0XN
i
LSQM2MPUD0 management and route unit
1 Card identifier
The card identifier LSQM2MPUD0 is in the upper right corner of the front panel.
2 Specifications
IMPORTANT:
•
The S7506E (non-PoE) does not support this card.
•
Before installing the card, you must remove the protection cover from the card to ensure correct
installation.
•
The 40G QSFP+ fiber module cannot be connected to a 10-Gbps SFP+ transceiver module
when the 40G QSFP+ fiber module is installed in this card.
Table 1 LSQM2MPUD0 specifications
Item Specifications
Flash 1 GB
SDRAM (DDR3) 4 GB
Card size (H × W × D) 40 × 399 × 355 mm (1.57 × 15.71 × 13.98 in)
Power consumption 55 W to 96 W
Ports
•
1 x console port
•
1 x USB console port
•
4 x network management ports: 2 × 10/100/1000BASE-T copper
ports and 2 SFP fiber ports
•
2 x QSFP+ ports
•
1 x USB port
Port speed
•
Console port:
≤
115200 bps (default: 9600 bps)
•
USB console port: ≤ 115200 bps (default: 9600 bps)
•
10/100/1000BASE-T copper port: 10/100/1000 Mbps, half/full
duplex
•
SFP fiber port: 1000 Mbps
•
QSFP+ fiber port: 40 Gbps
Transmission medium and max
transmission distance
•
Console port: 15 m (49.21 ft) over ordinary asynchronous serial
port cables
•
USB console port: 10 m (32.81 ft) over USB-AB cables
•
10/100/1000BASE-T copper port: 100 m (328.1 ft) over Category
5 or higher twisted pair cables
•
SFP fiber port: see Table 3
•
QSFP+ fiber port: see Table 4 , and Table 5
Compatible device models S7503E/S7506E/S7506E-V/S7510E
Applicable host software versions Version 7168 and later