HPE LSQM2MPUD0, Manual

Page: 2 / 4

Manual version: 6PW108-20180130 BOM: 3123A0XN
ii
NOTE:
•
To successfully connect an Ethernet port to a network management port (SFP port) on the card,
make sure the Ethernet port is operating in full duplex mode and at the port speed of 1000 Mbps.
•
H3C recommends not using a USB extender cable to connect the USB port.
The 10/100/1000BASE-T copper port uses an RJ-45 connector.
Figure 1 RJ-45 connector
Table 2 RJ-45 GE connector pinout
Pin
10BASE-T/100BASE-TX/1000BASE-T
Signal Function
1 MX_0+ Transmits and receives data.
2 MX_0- Transmits and receives data.
3 MX_1+ Transmits and receives data.
4 MX_2+ Transmits and receives data.
5 MX_2- Transmits and receives data.
6 MX_1- Transmits and receives data.
7 MX_3+ Transmits and receives data.
8 MX_3- Transmits and receives data.
Table 3 descirbes the SFP transceiver modules available for the SFP ports on the card.
Table 3 SFP transceiver module specifications
Module
Central
wavelength Connector
type Cable
specifications
Maximum
transmission
distance
SFP-GE-SX-MM850-A
850 nm LC
50/125 µm multi-mode
optical fiber (MMF)
550 m (0.34 miles)
850 nm LC 62.5/125 µm MMF 275 m (0.17 miles)
SFP-GE-SX-MM850-D
850 nm LC 50/125 µm MMF 550 m (0.34 miles)
850 nm LC 62.5/125 µm MMF 275 m (0.17 miles)
SFP-GE-LX-SM1310-A
1310 nm LC
9/125 µm single-mode
optical fiber (SMF)
10 km (6.21 miles)
1310 nm LC 50/125 µm MMF 550 m (1804.46 ft)
1310 nm LC 62.5/125 µm MMF 550 m (1804.46 ft)
PIN #8
PIN #1