HPE FlexNetwork 10500 SERIES, Configuration Manual

Page: 213 / 407

202
Verifying the configuration
# Display information about the policy.
[Sysname-rtm-test] display rtm policy registered
Total number: 1
Type Event TimeRegistered PolicyName
CLI CLI Aug 29 14:56:50 2013 test
# Enable the information center to output log messages to the current monitoring terminal.
[Sysname-rtm-test] return
<Sysname> terminal monitor
# Enter a question mark (?) at a command line that contains a letter d . Verify that the system displays
the "hello world" message and a policy successfully executed message on the terminal screen.
<Sysname> d?
debugging
delete
diagnostic-logfile
dir
display
<Sysname>d%May 7 02:10:03:218 2013 Sysname RTM/4/RTM_ACTION: "hello world"
%May 7 02:10:04:176 2013 Sysname RTM/6/RTM_POLICY: CLI policy test is running
successfully.
Track event monitor policy configuration example
Network requirements
As shown in Figure 57 , Device A has established BGP sessions with Device D and Device E. Traffic
from Device D and Device E to the Internet is forwarded through Device A.
Configure a CLI-defined EAA monitor policy on Device A to disconnect the sessions with Device D
and Device E when GigabitEthernet 1/0/1 connected to Device C is down. In this way, traffic from
Device D and Device E to the Internet can be forwarded through Device B.