HPA M1022, Owner'S Manual

Page: 8 / 24

6
M822FX-USB / M1022-USB
M822FX / M1022
(1). Channel Input Jacks
MIC JACKS
A 3-pin XLR-type connector is used for balanced low imped-
ance microphone inputs.(1: sleeve, 2: hot, 3:cold)
BALANCED LINE IN JACKS
A standard 1/4” phone jack is used for balanced or unbal-
anced line level signals. Examples of line level signals include
most electronic keyboards, synthesizers, turn-tables(with
appropriate pre-amps), tape decks and the line outputs from
other mixers.
(2). CHANNEL INSERT I/O JACK
These are input/output jacks located between the head-ampli-
r.
These jacks allow you to own graphic equalizers, compres-
1. INPUT/OUTPUT CONNECTORS
Front Panel Controls
Front Panel Controls
MAIN OUTPUT
AUX
FOOT SWITCH
LINE
INSERT
1
MIC
LINE 7
LINE 8
7 / 8
LINE
INSERT
2
MIC
LINE 3
LINE 4
3 / 4
MIC
LINE 5
LINE 6
5 / 6
MIC
TAPE IN REC OUT
LINE 7
LINE 8
EFX
HEADPHONE
CONTROL ROOM
MONO MONO MONO
AUX
RETURN
OUT IN
1
2 3 4 7 9 11
5 6 10 8
Tip:Output(Send to external device)
Sleeve:Ground
Ring:Input(Return from external device)
(3). CHANNEL INPUT JACKS
These are unbalanced stereo line input jacks. Two jack types
are provided phone type and RCA pin type.
(4). RETURN L (MONO), R Jack
These are unbalanced 1/4” phone-type line input jacks. The
signal received by these jacks is sent to the MAIN bus and
AUX bus. These jacks are typically used to receive a return
signal from an external effect (reverb, delay, etc.)
NOTE: These jacks can also be used as an auxiliary stereo
input. If you connect to the L (MONO) jack only, the mixer
will recognize the signal as monaural and will propagate the
identical signal on both L and R jacks
(5). TAPE IN JACKS
These RCA pin jacks input a stereo sound source. Use these
jacks when you want to connect a CD or DAT directly to the
mixer for monitoring.
NOTE: You can adjust the signal level using the TAPE IN
control in MAIN control section.
(6). REC OUT JACKS
The REC OUT jacks send the pre-fader signal from the master
bus for recording by the tape deck.
(7). SEND JACKS
* AUX
These are unbalanced phone jacks-type output jack.
This jack output the signal form AUX bus, respectively.You use
this jack, for example, to connect to an effector or to a cue box
or other such monitoring system.
* EFX
These are unbalanced phone jacks-type output jack that output
the signal form the EFFECT bus.
You use this jack, for example, to connect to an external effector
(8). FOOT SWITCH JACK (Applied only to M822FX/
M822FX-USB )
This phone input jack can connect to the foot switch.With the
foot switch, you can use your foot to toggle the digital effects
ON and OFF