2.
Lift the hard drive out of the computer (2).
3.
If it is necessary to disassemble the hard drive, perform the following steps:
a.
Disconnect the hard drive connector cable (1) from the hard drive.
b.
Pull the sides of the bracket away from the drive (2) to remove the pegs that secure the bracket to
the hard drive.
c.
Remove the hard drive bracket (3) from the hard drive.
The hard drive bracket and hard drive connector cable are available in the Hard Drive Hardware Kit,
spare part number 809537-001.
Reverse this procedure to install the hard drive.
34
Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Summary of Contents for x360 310 G2
Page 4: ...iv Safety warning notice ...
Page 8: ...viii ...
