4.
Install the Switch Hardware (Continued)
5/8-inch #12
screws
Wall or Under-Table
: Use a #1 Phillips (cross-head) screwdriver
to attach the supplied brackets to the switch using the eight 8-mm
M4 screws in the orientation shown.
For wall-mounting, the network ports must be facing up. Do
not
mount the switch with ventilation or fan ducts facing up or down.
(
See “Installation Precautions” on page 4.)
Attach the switch to the wall or wood surface with four 5/8-inch
number 12 wood or tap screws (not included).
5
. Power On the Switch.
6.
Configure the switch for operation on your network
(minimal configuration).
Using a standard Ethernet cable, connect a PC directly to the
switch.
Then configure the PC’s IP Address and Subnet Mask to allow it to
communicate with the switch through your PC’s Web browser.
Switch factory-default settings:
Parameter
Factory Default Setting
Password
<blank>
IP address
192.168.2.10
Subnet mask
255.255.255.0
Default gateway
not set
See the example on page 3.
Connect to
any port
7
. Connect Network Cables.
Note:
For transceiver connections, install and use only
HP mini-GBIC/SFP transceivers supported by the switch.
See “Mini-GBIC/SFP Installation Notes” on page 3.
2
V1810-48G_QSG-Jan2011.fm Page 2 Monday, March 21, 2011 10:36 PM
