1
HP V1810-48G Switch Quick Setup Guide
The switch drawings in this document are for illustration only and may not match your particular switch model.
For more detailed instructions and information to set up your switch, view or download the
Installation and Getting Started
Guide
for your switch at
www.hp.com/networking/support
.
1.
Unpack and check included parts.
■
Documentation kit
■
Switch
■
Accessory kit (installation hardware)
■
AC power cord
2.
Prepare for installation. To avoid personal injury or product damage, review the “Safety Precautions” on
3
. Power on and verify that Self-Test completes normally.
The switch does not contain a power switch. It is turned on
by connecting power through the AC power cord.
After Self-Test:
Power LED = On
Fault LED = Off
4.
Install the Switch Hardware.
Turn off the switch before installing the switch hardware.
Rack Mounting:
Use a #1 Phillips (cross-head) screwdriver to attach the accessory kit brackets to the switch using the
eight 8-mm M4 screws. Then use the four number 12-24 screws to secure the brackets to the rack.
Table or Desktop:
Attach the four self-adhesive pads
(included in the accessory kit) to the bottom corners of
the switch.
V1810-48G_QSG-Jan2011.fm Page 1 Monday, March 21, 2011 10:36 PM
