HP Surestore Tape Library Model 10/588, Hardware Manual

Page: 37 / 94

2-3
Setting the SCSI Address
■
Setting the SCSI Address
You set the SCSI robotic address from the LSM operator panel. You might need
to get the address from your systems administrator.
Refer to Figure 2-2 and Figure 2-3 to set the SCSI address.
Note: You cannot set the SCSI drive addresses from the LSM operator panel.
For DLT drives, your customer representative uses the switches on the
drive to set the SCSI drive addresses, as described in the installation
manual. For 9840 drives, SCSI drive addresses are set through the drive’s
front panel. This can only be done by a certified Customer Service
Engineer.
CAUTION:
During this procedure, the panel displays “Press Execute to Enter Lib
Size.” This is not normally an operator function. Altering the library size
can cause initialization errors or damage the hand if the size is set
incorrectly to full size when the library has a standard door instead of an
expansion door. Instead of pressing Execute, press Menu.