HP StorageWorks A7298A, Installation Manual

Page: 81 / 92

Regulatory Compliance Notices
81 Host Bus Adapter for Windows and Linux Installation Guide
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. Any modifications to this device - unless expressly approved by the
manufacturer - can void the user’s authority to operate this equipment under part
15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference and (2) This device must accept any
interference that may cause undesirable operation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
■
Consult the dealer or an experienced radio/TV technician for help.
Note: Additional information on the need to interconnect the device with shielded
(data) cables or the need for special devices, such as ferrite beads on cables, is
required if such means of interference suppression was used in the qualification test for
the device. This information will vary from device to device and needs to be obtained
from the EMC group or product manager.