Diagnostic and Configuration Utilities
74
Host Bus Adapter for Windows and Linux Installation Guide
ARBTOV = n
Values are milliseconds form 500 to 10000. Default = 1000.
Represents FC_AL arbitration time-out prior to LIP.
Class = n
Values from 0-2. Default = 2. Controls which Fibre Channel
Class will be used: 0 = Class 1, 1 = Class 2, 2 = Class 3.
EDTOV = n
Values are in milliseconds form 500 to 10000. Default =
1000. Represents error detect time-out value prior to LIP.
EnableDPC = n
Values 0 or 1. Default = 0. 0 = process I/O completion at
interrupt level, 1 = process at DPC level.
FrameSizeMSB = n
Values from 1-8. Default = 8. Controls the upper byte of the
receive FrameSize if issued in PLOGI. This lets the FrameSize
to be constrained on 256 byte increments from 256 (1) –
2048 (8).
HardALPA = 0xn
Values from 0x01 – 0xEF. Default = 0x01 lets the HBA use a
hard assigned loop address. NOTE: Only valid ALPAs can
be used (see Table 6-2).
LinkTimeOut = n
Values are in seconds from 1 – 500. Default = 60. Controls
the time-out at which link no longer busy requests but issues
SELECTION_TIMEOUT error status.
LogErrors = n
Values 0 or 1. Default = 0. 0 = don’t log general HBA/drive
errors. 1 = use Event Log to general errors.
NodeTimeOut = n
Values are in seconds from 1–255.
Default = 10. Controls the time-out at which a formerly
logged-in node will issue SELECTION_TIMEOUT error status
to an I/O request.
QueueDepth = n
Values from 1–64 (decimal). Default = 64. Requests per
LUN/Target (see Queue Target parameter).
QueueTarget = n
Vaules 0 or 1 (decimal). Default = 0. 0 = QueueDepth
applies on a per LUN basis: 1 = QueueDepth applies on a
Target basis.
RATOV = n
Values are in seconds from 2 to 120. Default = 2. This value
is the ELS request time-out.
ReadCheck = n
Values 0 or 1. Default = 1. 0 = do not enable byte counting
for read operations. 1 = enable byte counting. If bytes
counted are less than requested transfer count, issue
underrun.
Table 11: Driver Parameters (Continued)
Summary of Contents for StorageWorks A7298A
