HP StorageWorks 2/140 - Director Switch, Service Manual

Page: 34 / 396

Diagnostics
34 Director 2/140 Service Manual
Maintenance Analysis Procedures
Note: HAFM and Element Manager screens in this manual may not match the screens
on your server and workstation. The title bars have been removed, and the fields may
contain data that does not match the data seen on your system.
Fault isolation and related service procedures are provided through MAPs. The
procedures vary depending on the diagnostic information provided. MAPs consist
of step-by-step procedures that prompt service personnel for information or
describe a specific action to be performed. MAPs provide information to interpret
system events, isolate a director failure to a single FRU, remove and replace the
failed FRU, and verify director operation.
Factory Defaults
Table 3 lists the defaults for the passwords and IP, subnet, and gateway addresses.
Table 3: Factory-set Defaults
Quick Start
Table 4 lists the MAPs. Fault isolation normally begins at “ MAP 0000: Start
MAP ” on page 45.
Table 4: MAP Summary
Item Default
Customer password password
Maintenance password level-2
IP address 10.1.1.10
Subnet mask 255.0.0.0
Gateway address 0.0.0.0
MAP Page
MAP 0000: Start MAP 45
MAP 0100: Power Distribution Analysis 69
MAP 0200: POST Failure Analysis 78