Securing the device to the outer rails
To secure the device to the outer rails:
1.
Insert the switch with the attached inner rails into the outer rails.
NOTE:
This step applies to installing a device in HP 9000 Series, HP 10000 Series, or HP System/e
racks.
2.
Insert the device into the rack, and install one #10-32 x 1/2-inch Phillips panhead screw with
captive star lock washer. Repeat for the remaining side. (See
and
Figure 22 Securing the switch (HP 9000 Series or HP 10000 Series racks)
.
Figure 23 Securing the device in an HP System/e Rack
.
3.
Tighten the hex nuts installed in step 4 of
Installing the HP SAN Switch Rack Mount Kit in your
, page 36. (See
This completes the rack mount procedure.
8-Gb SAN Switch Hardware Reference Guide
43
