2.
Disconnect the display panel cable
(2)
and the control cable
(3)
from the system board.
3.
Remove the 7 Phillips PM2.5×4.0 screws
(1)
that secure the display assembly to the computer.
4.
Rotate the computer upward to open the display hinges, and then separate the display from
the computer
(2)
.
5.
If it is necessary to remove the clutch cover or the display hinges:
a.
Remove the clutch cover (the plastic piece on the bottom of the display) by pulling it straight
up to disengage it
(1)
.
b.
Remove the 4 Phillips PM2.5×5.0 screws (2 from each hinge) that secure the hinges to the
display.
c.
Remove the antennas and the control cable from the left hinge
(2)
.
Component replacement procedures
35
