Right trim and fingerprint reader
The right trim can include an integrated fingerprint reader. One cable connects to the fingerprint reader, and
six Torx screws secure the trim. Two of the screws are located under a plastic piece at the mouth of the optical
drive on models so equipped.
To remove the right trim:
1.
Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 31
).
2.
Remove the rear port cover (see
Rear port cover on page 31
).
3.
Remove the stand (see
Attaching and removing a stand on page 32
).
4.
Remove the access panel (see
Access panel on page 37
).
5.
If installed, remove the optical drive (see
Optical drive on page 41
).
6.
Remove the top trim (see
Top trim on page 45
).
7.
If installed, disconnect the fingerprint reader cable from the system board and remove the cable from
the routing path near the bottom of the computer.
80
Chapter 4 Removal and Replacement Procedures
Summary of Contents for ProOne 600 G2
Page 4: ...iv About This Book ...
Page 10: ...x ...