Attaching the computer to a mounting fixture
The computer can be attached to a wall, swing arm, or other mounting fixture.
IMPORTANT:
This computer supports the VESA industry standard 100 mm mounting holes. To attach a
third-party mounting solution to the computer, four 4 mm, 0.7 pitch, 20–mm long screws are required. These
screws are supplied with the computer. Longer screws must not be used because they may damage the
computer. It is important to verify that the manufacturer’s mounting solution is compliant with the VESA
standard and is rated to support the weight of the computer. For best performance, it is important to use the
power cord and other cables provided with the computer.
NOTE:
This apparatus is intended to be supported by a UL– or CSA–Listed wall-mount bracket.
1.
Remove the VESA trim plate from the rear of the computer.
2.
Insert the VESA mount bracket into the two large holes in the upper part of the back of the computer (1),
and then rotate it down.
3.
Secure the VESA mount bracket with two screws (2).
4.
Press the supplied VESA trim plate onto the VESA opening until it snaps into place (3).
12
Chapter 2 Setup