Hardware options installation 74
6.
Using a T-15 Torx screwdriver, secure the dedicated iLO 2 management port module.
7.
Install the access panel.
8.
Do one of the following:
o
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
9.
Connect a network cable to the module, as needed.
10.
Power up the server (on page
20
).
HP Trusted Platform Module option
Use these instructions to install and enable a TPM on a supported server. This procedure includes three
sections:
1.
Installing the Trusted Platform Module board (on page
75
).
2.
Retaining the recovery key/password (on page
76
).
3.
Enabling the Trusted Platform Module (on page
77
).
Enabling the TPM requires accessing the ROM-Based Setup Utility (RBSU) ("
HP ROM-Based Setup
Utility
" on page
85
). For more information about RBSU, see the HP website
(
http://www.hp.com/support/smartstart/documentation
).
TPM installation requires the use of drive encryption technology, such as the Microsoft® Windows®
BitLocker™ Drive Encryption feature. For more information on BitLocker™, see the Microsoft website
(
http://www.microsoft.com
).
CAUTION:
Always observe the guidelines in this document. Failure to follow these guidelines
can cause hardware damage or halt data access.
When installing or replacing a TPM, observe the following guidelines:
•
Do not remove an installed TPM. Once installed, the TPM becomes a permanent part of the system
board.
