Hardware options installation 62
To install the component:
1.
Power down the server (on page
20
).
2.
Do one of the following:
o
Unlock and remove the bezel ("
Open or remove the tower bezel
" on page
20
).
o
Extend the server from the rack (on page
21
).
3.
Remove the access panel (on page
21
).
4.
Remove the applicable media bay blanks ("
Remove the media bay blank
" on page
23
).
IMPORTANT:
For correct cabling, install the full-height tape drive in the top two slots.
5.
Identify the guide screws ("
Identifying guide screws
" on page
58
).
6.
Install the guide screws.
7.
Install the tape drive.
8.
Install a SAS controller ("
Installing expansion boards
" on page
64
).
9.
Connect the power cable to the rear of the drive.
