Removal and replacement procedures 43
CAUTION:
Do not operate the server for long periods with the access panel open or
removed. Operating the server in this manner results in improper airflow and improper cooling
that can lead to thermal damage.
IMPORTANT:
For optimum cooling, install fans in all primary fan locations. For more
information, refer to the fan locations table ("
To replace the component, reverse the removal procedure.
Fan cage
To remove the component:
1.
Power down the server (on page
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
o
Remove the server from the rack (on page
4.
Remove the access panel ("
5.
Remove the fan cage.
CAUTION:
Do not operate the server for long periods with the access panel open or
removed. Operating the server in this manner results in improper airflow and improper cooling
that can lead to thermal damage.
IMPORTANT:
For optimum cooling, install fans in all primary fan locations. For more
information, refer to the fan locations table ("
Summary of Contents for ProLiant DL380 Gen9
