6.
Press inward on the release lever at the rear of the device (1) and slide the device out of the rear
of the drive bay (2).
Installing a 3.5-inch device
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 92
).
2.
Remove the access panel (
Access panel on page 93
).
3.
Remove the front bezel (
Front bezel on page 94
). If you are installing a drive in a bay covered by
a bezel blank, remove the bezel blank. See
Bezel blanks on page 96
for more information.
4.
Install 6-32 guide screws in the holes on each side of the device.
NOTE:
HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to
Drives
on page 105
for an illustration of the extra guide screws location.
When replacing a device, transfer the four 6-32 guide screws from the old device to the new one.
Drives
109