HP ProCurve Secure 7102dl, Reference Manual

Page: 1273 / 1455

SROS Command Line Interface Reference Guide AS Path List Command Set
5991-2114 © Copyright 2006 Hewlett-Packard Development Company, L.P. 1271
AS P
ATH
L
IST
C
OMMAND
S
ET
To activate the Autonomous System (AS) Path List Configuration mode, enter the ip as-path-list
command at the Global Configuration mode prompt. For example:
ProCurve> enable
ProCurve# configure terminal
ProCurve(config)# ip as-path-list listname
ProCurve(config-as-path-list) #
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 1435
end on page 1436
exit on page 1437
All other commands for this command set are described in this section in alphabetical order.
deny <community-number> | internet | local-as | no-export | no-advertise] on page 1272
permit [
<community-number>
| internet | local-as | no-export | no-advertise] on page 1273