3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 41
).
5.
Remove the service door (see
Service door on page 42
).
To add or replace a memory module:
1.
Spread the retaining clips
(1)
on each side of the memory module slot to release the memory
module. (The memory module tilts up.)
2.
Remove the memory module
(2)
by pulling it away from the slot at an angle.
CAUTION:
To prevent damage to the memory module, hold the memory module by the edges
only. Do not touch the components on the memory module.
CAUTION:
To protect a memory module after removal, place it in an electrostatic-safe
container.
3.
Align the notched edge
(1)
of the memory module with the tab in the memory module slot.
4.
With the memory module at a 45-degree angle from the surface of the memory module
compartment, press the module into the memory module slot
(2)
until it is seated.
48
Chapter 4 Removal and replacement procedures
ENWW
