Chapter 3
Mount the Drive in the NetServer E 45 or E 50
18
Power
Switch
Flexible Disk
Controller
Flexible Disk
CD-ROM
System Board
IDE1
IDE2
F5
D5
C33
C33
D5
F5
*
SCSI Card
PCI 1
Shelf 1
Shelf 2
Shelf 3
Shelf 4
Shelf 5
Shelf 6
*
Key
Available Connector
Engaged Connector
50-pin SCSI Cable
IDE CD-ROM Cable
Flexible Disk Cable
Built-in SCSI Terminator
For cabling options and connector locations, see the
Technical Reference Label inside your HP NetServer chassis.
Figure 3-1. NetServer E 45 Shelf Positions and Cabling Options
•
Use the guidelines in Table 3-1 to determine the proper location within
your HP NetServer E 45 to install your hard disk drive.
Table 3-1. Mass Storage Device Locations and SCSI ID Settings
Device
Location
SCSI Address
Standard Hard Drive
(in models that
include one)
Shelf 5
0 (default)
HP Accessory 9 GB
HD (P1213A)
Shelf 3, 4, 5
or 6
0, if it is the first hard drive; for
subsequent drives, use address 1, 2
or 3
HP SureStore T4i
Shelf 3 or 4
4 (default)
HP SureStore 8i,
5000i, 2000i
Shelf 3 or 4
2 (default)
(can be set to any unused address)
Standard SCSI
Controller
PCI 1 Slot
7
•
If the drive is in a factory-provided tray, place the drive on a flat surface
free from static electricity with the circuit board on the drive facing up.
Remove the four screws that attach the drive to the tray and remove the
drive. (These screws can be used to mount the drive in the HP NetServer
E 45.)