Synchronizing the Wireless Devices
The wireless keyboard in the kit is shipped pre-synchronized from the factory. The wireless mouse
should be synchronized during initial setup. You only need to synchronize the devices again if you
replace either the keyboard, mouse, or USB receiver.
1.
Ensure that the computer is turned on, the batteries are installed in the keyboard and mouse, the
switch on the bottom of the mouse is in the On position, and the USB receiver is plugged into a
USB port on the computer.
NOTE:
The keyboard and mouse should be within 30 cm (1 foot) of the receiver and away
from interference from other wireless devices.
2.
Press the Connect button on the receiver for approximately five seconds. The status light on the
receiver will flash for a few seconds when the Connect button is pressed.
3.
While the status light on the receiver is flashing, quickly press the Connect button on the
underside of the keyboard.
4.
Press the Connect button on the receiver again for approximately five seconds. The status light
on the receiver will flash for a few seconds when the Connect button is pressed.
5.
While the status light on the receiver is flashing, quickly press the Connect button on the
underside of the mouse.
8
Chapter 2 Troubleshooting
ENWW
Summary of Contents for KKBRF57711
Page 1: ...HP Wireless Keyboard Mouse Installation Guide ...
Page 4: ...iv About This Guide ENWW ...
Page 6: ...vi ENWW ...
