HP Kayak XU 03xx PC Workstation — Installing Accessories In Your HP PC Workstation
Installing Mass Storage Devices
22
English
Before Installing an
IDE Device
Refer to the drive’s installation guide to see if you must set jumpers or
if there is a special installation procedure to follow.
Before Installing a
SCSI Device
If you are installing a SCSI device, refer to the section “Before Installing
a SCSI Hard Disk” on page 15 before using the following instructions.
1
Disconnect the computer’s power cord and any telecommunications
cable.
2
Remove the computer’s cover (refer to page 3).
3
Slide out the power supply to provide better access to the disk drive
cables (see page 6).
4
If installing a drive in a 5.25-inch wide shelf, remove the drive tray
and put it in a safe place.
5
Slide the drive into the shelf.
6
Secure the drive in position using the screws provided with the
drive.
7
Locate the appropriate data cable for the device.
Remove the
drive tray if
installing a
5.25-inch drive
Slide the drive
into position
Mounting Rails
Secure the drive
in position
03xx-i~1.fm Page 22 Tuesday, February 16, 1999 10:15 AM