HP J9573A, Manual

Page: 25 / 36

23
Version KA.15.10.0007
Status: Released and fully supported, but not posted on the web.
The following problems were resolved in software version KA.15.10.0007.
■ Authentication (CR_0000122439)
- With multiple certificates installed on the switch, PEAP-MSCHAPv2
authentication fails when using Windows Server 2008 R2 Network Policy Server (NPS).
■ Crash (CR_0000122225)
- The switch might reboot unexpectedly when using VRRP with a message similar to
Software exception in ISR at btmDmaApi.c:378
.
■ Crash (CR_0000124443)
- Rarely, when ports go offline, then back online while voice VLAN requests are being
sent, the switch might reboot unexpectedly with a message similar to
Software exception at sw_sem.c:1036 -- in 'mSnmpCtrl' -> Deadlock found!
.
■ IGMP (CR_0000105902)
- IGMPv2 LEAVE processing functionality no longer works for a multicast group after
receipt of IGMPv1 group specific membership query (GSMQ) packet when operating in IGMPv2 mode, even when ip
igmp forcedfastleave 1-24 is enabled.
■ SNMP (CR_0000124187)
- With stacking enabled, the time-stamps in SNMP traps do not match sysUptime on the
switch.
■ SNMP (CR_0000124375)
- A switch configured to send syslog messages to a server also sends incorrect SNMP
traps, causing
unknown trap
messages in the syslog server.
■ TFTP (CR_0000124276)
- The switch experiences a loss of free memory each time the CLI command copy running-
config tftp is issued by a user or by a network management platform. When memory is depleted on the commander,
the switch will respond to CLI commands such as show run with the error message
Translator Failed
. In that
state, stack configuration changes might cause 3800 stack members to reboot repeatedly with a message similar to
Reboot of Member ID 2, RFS Error reboot
.
Version KA.15.10.0008
Status: Released and fully supported, but not posted on the web.
The following problems were resolved in software version KA.15.10.0008.
■ Authentication (CR_0000114307) - The switch does not allow users to login when the configured authentication
method is
peap-mschapv2
.
■ Crash (CR_0000126636) - It is possible for the switch to reboot unexpectedly, under conditions of very high traffic
volumes and high CPU utilization.
Version KA.15.10.0009
Status: Released and fully supported, and posted on the web.
The following problems were resolved in software version KA.15.10.0009.
■ ACLs (CR_0000122535)
- When configuring an ipv4 or ipv6 prefix-list, it is not possible to add an entry to permit/
deny 'any'.
■ CLI (CR_0000125980)
- After configuring debug ip pbr , the output of show debug does not include pbr in the list of
enabled debug types.
■ CLI (CR_0000127335)
- Using the CLI command show tech all can cause the system to reboot unexpectedly.
■ Crash (CR_0000120116)
- With OSPF configured, in a rare situation the switch might reboot unexpectedly with a
message similar to
Software exception at rt_table.c:4453 -- in 'eRouteCtrl', task ID = 0xa9c4c00 ->
Routing Stack: Assert Failed.