HP J3591A, User Manual

Page: 4 / 6

7. Access the device through your Web browser on the same
subnet by typing the following URL: http://192.0.0.192.
8. Follow the instructions on the screen:
* User Parameters: configure a User Administrator
* Network Parameters: Web Console IP address, system name
The Console will then reboot automatically.
9. Now you can connect the serial cable (diagram C p. 4).
❑
Resetting the Configuration
It may be necessary to reset your HP Secure Web Console to the
factory settings if, for example, the password has been lost.
Warning! All configuration data will be lost.
1. Power off the console by unplugging the power cable.
2. Press the button on the top of the console (as shown in
diagram D) and keep it pressed.
3. Power on the box by replugging the power cable.
4. Release the button after a couple of seconds.
Follow the Initial Configuration steps again.
a. route add 192.0.0.192 <client_host IP address>
Example: route add 192.0.0.192 15.128.122.12
b. ping 192.0.0.192. If ping is successful, follow the
instructions Step 7, else proceed with Step c below.
c.
a
rp -s 192.0.0.192 < WEB Console MAC_address>
The MAC address of the HP Secure Web Console is
marked on the top of the device and also on the box used
for shipment.
UNIX Workstations: 00:60:b0:22:3e:ae
PCs: 00-60-b0-22-3e-ae
format, as shown below:
Note: the MAC address must be entered in the appropriate
Note : During the configuration of your HP Secure Web Console,
you must configure an IP gateway in the “configure IP” screen.
If you do not have a valid IP gateway, enter the same IP
address as you entered for the HP Secure Web Console.
Button for
D
reset to
factory
settings
❑
Support from the World Wide Web
HP provides product and support information from the World
Wide Web to enable you to identify and resolve problems. You
can access this site at:
World Wide Web Site Overview:
•
PRODUCT provides Product supported features:
- product brief
- sideshows presentation
•
SUPPORT:
Installation & Documentation (on-line version of this
guide)
Troubleshooting Flowcharts to guide you step-by-step
through web console problems
Frequently Asked Questions (FAQs) about Product
setup and usage
Downloading & Patches allows you to upgrade from the
WEB to the latest product revision
HP Support Services & Warranty gives contacts within
the HP support organization for technical assistance and a
description of the HP warranty policy
•
SOLUTIONS provides other general Product information
Main Hints:
•
Use the Troubleshooting Flowcharts to identify your
problem.
• Use HP Support Services and Warranty to find out how to
contact HP for technical assistance.
• Upgrade to the latest Firmware from the Support WEB site
(Downloading & Patches).
• Use temporarily a regular terminal if your HP Secure WEB
Console is defective.
HP Technical Assistance:
You can find how to contact HP from the World Wide Web site
http://www.hp.com/go/webconsole, under “Support” and “HP
Support Services” menu.
Before contacting HP, make sure you have the serial number of
your HP Secure WEB Console.
http://www.hp.com/go/webconsole
6
7