HP J3168A, User Manual

Page: 24 / 110

3-2 Network Configuration
Chapter 5 describes different methods that you can use to set
the NetWare configuration in the HP CD-ROM Server; the
required configuration settings are described below.
The NDS server installation will begin 5 seconds after saving
the configuration settings to the CD-ROM server. The
installation should take about 20 seconds, after which users will
be able to access the CD-ROM server using NDS mode.
Refer to chapter 4 for instructions on accessing your CD-ROM
server.
After installation you will have to logout and then login again to
have all the necessary Rights on the HP CD-ROM Server object
and the associated volume. Using NetWare Administrator, you
will find a new server object and corresponding volume object in
the context you chose above.
If there are any problems with the installation you can check for
errors in the
logfile.txt file in the CD-ROM Server’s config
directory. Refer to “ NetWare NDS Installation Errors ” in
appendix A if you need more information.
Parameter name Value Description
TimeZone =
Must be set to the correct Time Zone
that the CD-ROM server is operating in.
TimeSyncSource = None
Default is None. Set to NDS to enable
the HP CD-ROM Server to get its time
from the NetWare network.
NDSEnable = yes
Must be set to yes to enable the NDS
login.
NDSTreeName =
The name of the tree that you want to
install the server into.
NDSServerContext =
The context in the NDS tree where you
want to install the server.
NDSAdminName =
The distinguished name of a user or
administrator with Supervisor or Create
rights in the context where you want to
install the server.
NDSAdminPassword =
The password of the administrator
entered in NDSAdminName shown
above. Once written, this password will
appear as ******.
NDSInstall = no
Change this to yes when you are ready
to install the server.
hp.book Page 2 Thursday, April 2, 1998 4:33 PM