HP J3138A, Installation Manual

Page: 35 / 104

3-5
Configuring the HP AdvanceStack Internet Router
Configuring the Router for the First Time
C
o
nfi
gurat
ion
1 ISDN Basic Rate interface.
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read ONLY)
Notice: NVRAM invalid, possibly due to write erase.
--- System Configuration Dialog ---
At any point you may enter a question mark ’?’ for help.
Refer to the ’Getting Started’ Guide for additional help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets ’[]’.
Would you like to enter the initial configuration dialog? [yes]:
3. Press
Return
or enter
yes
to begin the configuration process.
4. When the System Configuration Dialog asks whether you want to view the
current interface summary, press
Return
or enter
yes
:
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value “NO” does not have a valid
configuration
Interface* IP-Address OK? Method Status Protocol
Ethernet0 unassigned NO not set up down
BRI0 unassigned NO not set up up
Serial0 unassigned NO not set down down
Serial1 unassigned NO not set down down
*If you are attached to a VG device, you will see the speficiation
for VG0
5. Configure the global parameters. A typical configuration follows:
Configuring global parameters:
Enter host name [Router]:
Next, you are prompted to enter an enable secret password. There are two
types of privileged-level passwords:
• Enable secret password (a very secure, encrypted password)
• Enable password (a less secure, nonencrypted password)
The enable password is used when the enable secret password does not
exist.
For maximum security, be sure the passwords are different. If you enter
the same password for both, the router will not accept your entry.