Chapter 4
Procedures
24
Installing Keyboard Shelf
This kit requires 2 EIA units in your HP rack.
Contents
2
Rear Brackets
2
Sheet Metal Nuts
1
Keyboard Kit Assembly
2
Decorative Gray Screws
2
Torx 25 Screws with Lock Washers
2
Spare Mouse Cable Clips
Tools Needed: Torx 25 Driver
NOTE: Extend the rack’s four stabilizer feet
before installing components in the rack.
67(3
Choose EIA location for the keyboard.
Determine whether the operator will sit or stand
while using the keyboard, and locate the EIA unit
that places the bottom of the Keyboard Tray at the
correct height.
67(3
Position and attach Rear Brackets.
Position the bottoms of the Rear Brackets at the
desired EIA location. Install with two non
decorative Torx 25 bolts.
EIA location
67(3
Install Sheet Metal Nuts in front columns.
On the middle hole of the EIA unit located in
Step 1, place sheet metal nuts on the front
columns as shown. (The shown EIA location is an
example location.)
EIA location
67(3
Install Keyboard Tray.
Standing in front of the rack and holding the front
of the Keyboard Tray, move it to the rear. The
pins pointing in on the Rear Brackets fit into the
channels cut into the back of the Keyboard Tray.
Align the front of the kit at the EIA location.
3
0
3
1
3
2
Side view
