16
Mounting the switch in the rack
This task requires two people.
To mount the switch in the rack:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Verify that the mounting brackets and chassis rails have been securely attached to the switch
chassis.
3.
Verify that the slide rails have been correctly attached to the rear rack posts.
4.
Install cage nuts (user-supplied) to the front rack posts and make sure they are at the same
level as the slide rails.
5.
One person performs the following operations:
a.
Supporting the bottom of the switch, aligns the chassis rails with the slide rails on the rack
posts.
b.
Pushes the switch slowly to slide the chassis rails along the slide rails until the mounting
brackets are flush with the rack posts.
6.
Another person uses screws (user-supplied) to attach the mounting brackets to the rack.
To secure the switch in the rack, make sure the front ends of the slide rails reach out of the
chassis rails.
The rack-mounting procedures are the same for the HPE 5930-32 QSFP+/HPE 5930-32 QSFP+
TAA/HPE 5930-2Slot+2QSFP+/HPE 5930-2Slot+2QSFP+ TAA switches. The following figures use
the HPE 5930-2Slot+2QSFP+/HPE 5930-2Slot+2QSFP+ TAA switch as an example.
Figure 18 Mounting the HPE 5930-2Slot+2QSFP+/HPE 5930-2Slot+2QSFP+ TAA switch in the
rack (power supply-side mounting position for the mounting brackets)
