![HP FlexFabric 11908-V Installation Manual Download Page 20](http://html.mh-extra.com/html/hp/flexfabric-11908-v/flexfabric-11908-v_installation-manual_165866020.webp)
14
HP recommends using a mechanical lift for moving your switch.
3.
Place the switch on the slide rails and slide the switch along the slide rails until the mounting
brackets on the switch touch the front rack posts, as shown in callout 1 on
.
4.
Attach the chassis to the rack with mounting screws.
Figure 10
Installing the chassis to the rack
(1) Slide the chassis into the rack
(2) Mounting brackets
(3) Screws for attaching the mounting brackets to the rack
NOTE:
If the mounting holes in the mounting brackets cannot align with the cage nuts on the rack, verify that the
bottom edge of the slide rail aligns with the middle of the narrower metal area between holes and that the
cage nuts are installed in the correct holes.
Mounting the switch on a workbench or floor
You can install the switch on a clean, sturdy workbench or on the floor.
Installation preparation
Before you mount the switch on a workbench or on the floor:
•
Position the installation holes and drill holes. Make sure the holes are exact in diameter and depth
for the anchors to work correctly.
•
Remove the shank and plug from a wall anchor, insert the spade-shaped wedges into the grooves
on the shank, put them into an installation hole, and hammer the shank into the ground. See
Summary of Contents for FlexFabric 11908-V
Page 6: ...iv Index 97 ...
Page 78: ...72 ...