HP FC Switch Surestore 6164, Reference Manual

Page: 65 / 236

Maintenance Procedures 65
d. Specify the new IP address by entering the following:
ipAddrSet
e. Enter the following information at the corresponding prompts:
–
Ethernet IP Address [current]:
Enter new Ethernet IP
address (the default is 10.77.77.77).
–
Ethernet Subnetmask [current]:
Enter new Ethernet
subnetmask (the default is 0.0.0.0).
–
Fibre Channel IP Address [current]:
Enter new fibre
channel IP address if desired.
–
Fibre Channel Subnet Mask [current]:
Enter new fibre
channel subnet mask if desired.
–
Gateway Address [current]:
Enter new gateway address
(the default is 172.17.1.1).
–
Set IP address now? [y = set now, n = next
reboot]:
Enter “
y
” to set the IP address now by rebooting the
switch.
f. You can verify the address was correctly set by entering the following:
ipAddrShow
12.Log on with administrative privileges to the new switch, using a Telnet
connection.
13.From a computer workstation, disable the diagnostic tests that run after
each reboot by entering the following at the Telnet prompt:
diagDisablePost
14.Set the domain ID to the value used by the previous switch, if still
available.
The default domain IDs on the six original switches shipped with the FC
6164 are (starting with switch 1) 231, 232, 233, 234, 235, and 236.