remainder is assigned to single channel. If one channel will have more memory than the other, the larger
amount should be assigned to channel A.
●
In any mode, the maximum operational speed is determined by the slowest memory module in the system.
Installing memory modules
There are two memory slots on the system board. To remove or install memory modules:
1.
Remove the access panel.
For instructions, see
Removing the computer access panel on page 24
2.
To locate the memory modules on the system board, see
Locating internal components on page 26
3.
To remove a memory module, press outward on the two latches on each side of the memory module (1),
then pull the memory module out of the slot (2).
4.
Slide the new memory module into the slot at approximately a 30° angle (1), then press the memory
module down (2) so that the latches lock it in place.
NOTE:
A memory module can be installed in only one way. Match the notch on the module with the tab on
the memory slot.
5.
Reinstall the access panel.
For instructions, see
Replacing the computer access panel on page 25
6.
Turn on the computer. The computer automatically recognizes the additional memory when you turn on
the computer.
28
Chapter 3 Hardware repair and upgrade
