9.
Pivot the display panel upward until it sits at a 90 degree angle
(3)
.
10.
Disconnect the display panel cable from the back of the display panel
(1)
.
11.
Remove the six Phillips PM2.5×5.0 screws
(2)
that secure the display panel to the brackets.
12.
Slide the display panel up and out of the hinges
(3)
.
Reverse this procedure to reassemble and install the display assembly components.
When replacing the display panel, after connecting the display cable, slide the panel into the bracket
(1)
, replace the screws
(2)
, and then rotate the panel assembly downward so it lies flat in the
enclosure
(3)
. Make sure to insert the display panel brackets into the notches in the corners of the
display enclosure
(4)
.
68
Chapter 4 Removal and replacement procedures
