m. Open the display and remove rubber spacer strips.
n.
Replace the hinge cover by positioning the cover over the bottom of the display, rotating the cover
upward, sliding it to the left, and then replacing the screw.
11.
When installing the display hinges, use the following illustration to determine proper cable routing. The
WWAN antenna cables and display cable route through the right hinge (1). The WLAN antenna cables and
display cable route through the left hinge (2).
12.
If you need to remove the hub board from the display:
a.
Disconnect the display cable from the ZIF connector (1) on the hub board.
b.
Disconnect the camera cable from the ZIF connector (2) on the hub board.
c.
Disconnect the smaller cables from the reverse ZIF connectors on the hub board (3).
d.
Use a tool (4) to release the board from the display rear cover (5).
The hub board is available as spare part number M07211-001 in models with an IR camera and
M07210-001 in models with an RGB camera or microphone module.
66
Chapter 6 Removal and replacement procedures for authorized service provider parts
